Electric doors are all kinds of doors that are driven by motors. Jiuzheng Building Materials Network will introduce you to the installation and maintenance methods of electric doors:
Installation of electric door:
(1) determining the position of the indoor control box, that is, the position of the device that operates the telescopic door switch;
(2) Leading the 220V power supply to the lower end of the control box. It is better to have one grounding wire, the thickness specification is 1.37, and there is a leakage protection device, and PVC is used for darkening;
(3) Reserve ¢32mm PVC pipe, from the lower end of the control box down to the ground level, through the wall to the outside, to 0.1-0.15 meters below the ground plane of the track, for the outdoor door of the retractable door to enter the room;
(4) According to the above table, the length of the door opening is obtained. When the door is opened, the clearance in the width of the hole is not less than 0.75-0.8 meters. The height of the ordinary door is not less than the height of the door + 0.25 m, and the door is not less than the height of the door + 0.1 m. The upper end of the inner side of the end is 0.4 m wide and 0.6 m high, and the total length of the door can be increased by 0.2-0.3 m. This can be used to change the access hole into a small door for easy maintenance and maintenance of the retractable door. line;
(5) Before leaving the track, except for leaving about 0.8-0.9 meters wide, do the ground on both sides first; after 2-3 days (5-7 days in winter), while laying the track, the civil works will be coordinated At the ground, pay attention to the passage of the road during the laying of the track, so as not to bend the track;
(6) Install the retractable door, connect the line, and debug the switch control box.
Maintenance of electric door:
In the process of using the electric door, the force should be light and not too large. When opening the electric door, be careful not to have obstacles. If there is any, remove the power supply and clean it.
Electric doors should always clean the surface. Wipe the occasional soft cotton cloth to avoid the surface of the electric door being scratched. If there are stains, it can be washed with water or alcohol.
It is important to avoid cleaning the electric door to avoid acid and alkaline substances.
Always do the daily maintenance of the electric door, the flexibility of all kinds of accessories. If it is found that there is damage, repair or replace it in time. The hardware has been used for a long time. You can apply a little fire wax oil or drip some oil to reduce the friction and keep the electric retractable door open and closed easily and flexibly. The sealing tops and glass strips of electric retractable doors are the two key components for sealing and heat preservation. If there is aging and loosening, they should be replaced in time.
6 Person Hot Tub
6 Person Hot Tub,outdoor spas and hot tubs,round outdoor hot tubs,indoor outdoor spa,outdoor hot tub spa
Guangzhou Aijingsi Sanitary Products Co.,Ltd , https://www.comoxvalleyhottubs.com